Several varieties of partitioning programs have been adapted by Debian developers to work on various types of hard disks and computer architectures. Following is a list of the program(s) applicable for your architecture.
Recommended partitioning tool in Debian. This swiss army knife can also resize partitions, create filesystems and assign them to the mountpoints.
The original Linux disk partitioner, good for gurus; read the fdisk manual page .
Be careful if you have existing FreeBSD partitions on your machine. The installation kernels include support for these partitions, but the way that fdisk represents them (or not) can make the device names differ. See the Linux+FreeBSD HOWTO
One of these programs will be run by default when you select . If the one which is run by default isn't the one you want, quit the partitioner, go to the shell (tty2) by pressing Alt and F2 keys together, and manually type in the name of the program you want to use (and arguments, if any). Then skip the step in debian-installer and continue to the next step.
If you will be working with more than 20 partitions on your ide disk, you will need to create devices for partitions 21 and beyond. The next step of initializing the partition will fail unless a proper device is present. As an example, here are commands you can use in tty2 or under Execute A Shell to add a device so the 21st partition can be initialized:
# cd /dev # mknod hda21 b 3 21 # chgrp disk hda21 # chmod 660 hda21 |
Booting into the new system will fail unless proper devices are present on the target system. After installing the kernel and modules, execute:
# cd /target/dev # mknod hda21 b 3 21 # chgrp disk hda21 # chmod 660 hda21 |
Make sure you create a “Sun disk label” on your boot disk. This is the only kind of partition scheme that the OpenBoot PROM understands, and so it's the only scheme from which you can boot. The s key is used in fdisk to create Sun disk labels.
Furthermore, on SPARC disks, make sure your first partition on your boot disk starts at cylinder 0. While this is required, it also means that the first partition will contain the partition table and the boot block, which are the first two sectors of the disk. You must not put swap on the first partition of the boot drive, since swap partitions do not preserve the first few sectors of the partition. You can put Ext2 or UFS partitions there; these will leave the partition table and the boot block alone.
It is also advised that the third partition should be of type “Whole disk” (type 5), and contain the entire disk (from the first cylinder to the last). This is simply a convention of Sun disk labels, and helps the SILO boot loader keep its bearings.