Debian does not impose hardware requirements beyond the requirements of the Linux kernel and the GNU tool-sets. Therefore, any architecture or platform to which the Linux kernel, libc, gcc, etc. have been ported, and for which a Debian port exists, can run Debian. Please refer to the Ports pages at http://www.debian.org/ports/s390/ for more details on S/390 architecture systems which have been tested with Debian.
Rather than attempting to describe all the different hardware configurations which are supported for S/390, this section contains general information and pointers to where additional information can be found.
Debian 3.1 supports eleven major architectures and several variations of each architecture known as 'flavors'.
Architecture | Debian Designation | Subarchitecture | Flavor |
---|---|---|---|
Intel x86-based | i386 | vanilla | |
speakup | |||
linux26 | |||
Motorola 680x0 | m68k | Atari | atari |
Amiga | amiga | ||
68k Macintosh | mac | ||
VME | bvme6000 | ||
mvme147 | |||
mvme16x | |||
DEC Alpha | alpha | ||
Sun SPARC | sparc | sun4cdm | |
sun4u | |||
ARM and StrongARM | arm | netwinder | |
riscpc | |||
shark | |||
lart | |||
IBM/Motorola PowerPC | powerpc | CHRP | chrp |
PowerMac | pmac | ||
PReP | prep | ||
APUS | apus | ||
HP PA-RISC | hppa | PA-RISC 1.1 | 32 |
PA-RISC 2.0 | 64 | ||
Intel ia64-based | ia64 | ||
MIPS (big endian) | mips | SGI Indy/Indigo 2 | r4k-ip22 |
r5k-ip22 | |||
Broadcom BCM91250A (SWARM) | sb1-swarm-bn | ||
MIPS (little endian) | mipsel | Cobalt | cobalt |
DECstation | r4k-kn04 | ||
r3k-kn02 | |||
Broadcom BCM91250A (SWARM) | sb1-swarm-bn | ||
IBM S/390 | s390 | IPL from VM-reader and DASD | generic |
IPL from tape | tape |
This document covers installation for the S/390 architecture. If you are looking for information on any of the other Debian-supported architectures take a look at the Debian-Ports pages.
Complete information regarding supported S/390 and zSeries machines can be found in IBM's Redbook Linux for IBM eServer zSeries and S/390: Distributions in chapter 2.1 or at the technical details web page at developerWorks. In short, G5, Multiprise 3000, G6 and all zSeries are fully supported; Multiprise 2000, G3 and G4 machines are supported with IEEE floating point emulation and thus degraded performance.